Ender 5 Plus + Klipper: Difference between revisions
| Line 18: | Line 18: | ||
''make menuconfig'' will ask for microcontroller - the E5+ uses atmega2560. See [https://github.com/KevinOConnor/klipper/blob/master/config/printer-creality-ender5plus-2019.cfg printer-creality-ender5plus-2019.cfg] | ''make menuconfig'' will ask for microcontroller - the E5+ uses atmega2560. See [https://github.com/KevinOConnor/klipper/blob/master/config/printer-creality-ender5plus-2019.cfg printer-creality-ender5plus-2019.cfg] | ||
Be sure to continue to [https://www.klipper3d.org/Config_checks.html Config_checks] BEFORE you try to print!! | Be sure to continue to [https://www.klipper3d.org/Config_checks.html Config_checks] BEFORE you try to print!! | ||
* https://www.klipper3d.org/Manual_Level.html | * [https://www.klipper3d.org/Manual_Level.html Manual Leveling] | ||
* https://www.klipper3d.org/Probe_Calibrate.html | * [https://www.klipper3d.org/Probe_Calibrate.html Probe Calibration] | ||
* https://www.klipper3d.org/Bed_Level.html | * [https://www.klipper3d.org/Bed_Level.html Bed Leveling] | ||
Revision as of 12:54, 10 October 2020
Purpose
I would like to unleash the power of my Ender 5 Plus(here after referenced as E5+) by removing the "bottleneck" that the weak mainboard processing power have. Klipper supposedly should do just this by moving all data processing from the E5+ mainboard on to the Raspberry Pi 4 i got connected already anyway.
First try/step will be a combo of Klipper and OctoPrint.
Later i might try the Klipper + Moonraker + MainSail combo.
Reference pages
- Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers.
- OctoPrint provides a snappy web interface for controlling consumer 3D printers.
- Moonraker is a Python 3 based web server that exposes APIs with which client applications may use to interact with Klipper.
- Mainsail lightweight & responsive web interface for the Klipper 3D printer firmware.
Klipper + OctoPrint combo
An installation guide is avilable on the Klipper website. I will follow that now.
make menuconfig will ask for microcontroller - the E5+ uses atmega2560. See printer-creality-ender5plus-2019.cfg
Be sure to continue to Config_checks BEFORE you try to print!!