Klipper + ADXL345 Input Shaper guide

From munkjensen.net/wiki
Revision as of 10:58, 27 November 2021 by Admin (talk | contribs) (Created page with "=== Guide === # Aquire an ADXL345 # Solder 6 wires on to the ADXL345. # Monut the ADXL to you Extruder. If you got a moving printbed as X you need to move the ADXL345 halfway...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Guide

  1. Aquire an ADXL345
  2. Solder 6 wires on to the ADXL345.
  3. Monut the ADXL to you Extruder. If you got a moving printbed as X you need to move the ADXL345 halfway into the calibration guide. Watch NEROs video!
  4. Connect the 6 wires to your Raspberry Pi - DO it correct please or you COULD risk frying either your ADXL345, Your Raspberry Pi... or both ;-)
  5. Install the software - if you havent done so already.
    1. Update your Raspberry Pi:
sudo apt update -y
sudo apt upgrade -y

Credits

I wrote this guide using NERO 3Ds Youtube video as inspiration, so I hade the commands needed handy to cut'n paste into my Raspberry Pi when ever I want to rerun the calibration.

Retrieved from "https://munkjensen.net/wiki/index.php?title=Klipper_%2B_ADXL345_Input_Shaper_guide&oldid=1719"